The Marshall CV620-CABLE-06 adapts the controller end of an RS-232 camera-control run to CAT cabling. It is intended for the VS-PTC-200 controller connection and uses RJ45 for serial wiring.
Marshall CV620-CABLE-06 Features
- Controller-side adapter set. The set belongs at the VS-PTC-200 end of the control run. Keeping the controller and camera adapters identified avoids swapping unlike ends when assembling the serial cable path.
- Serial connectors to CAT cable. The VGA/8-pin serial connection arrangement adapts to RJ45 CAT cabling. This supports routing the control run using CAT cable while retaining the controller's required serial connection.
- RS-232 rather than Ethernet. RJ45 carries serial control in this application. It must be wired for the controller and camera arrangement and kept separate from Ethernet or PoE switch ports.
Specifications
| Manufacturer | Marshall Electronics |
|---|---|
| Model | CV620-CABLE-06 |
| Location | Controller-side adapter set |
| Signal | RS-232 serial control |
| Connections | VGA/8-pin serial to CAT cable via RJ45 |
| Compatibility | VS-PTC-200 controller |
Technical Questions
What is specified for location?
Controller-side adapter set.
What is specified for signal?
RS-232 serial control.
What is specified for connections?
VGA/8-pin serial to CAT cable via RJ45.
Which equipment is listed as compatible?
VS-PTC-200 controller.
Buying and Installation Questions
What is the CV620-CABLE-06 used for?
It is intended for the compatible equipment and installation described in the specifications.
What should I check before ordering?
These RJ45 connections carry serial control. Do not connect them to an Ethernet or PoE switch.
