The Marshall CV620-CABLE-07 provides the camera-side adapter arrangement for an RS-232 control run using CAT cabling. It connects the serial camera end to the RJ45 cable path.
Marshall CV620-CABLE-07 Features
- Camera-side connection. This adapter set is intended for the camera end of the serial run. It complements the appropriate controller-side arrangement rather than serving as an interchangeable adapter at either end.
- 8-pin serial to RJ45. The connection adapts the camera's 8-pin serial interface to CAT cable through RJ45. This provides a practical cable-routing arrangement for an installed serial camera-control system.
- Serial-only cable path. The RJ45 connection carries RS-232 control and is not an Ethernet interface. Keep it away from PoE/network ports and use the prescribed serial wiring for the camera system.
Specifications
| Manufacturer | Marshall Electronics |
|---|---|
| Model | CV620-CABLE-07 |
| Location | Camera-side adapter set |
| Signal | RS-232 serial control |
| Connections | 8-pin serial to CAT cable via RJ45 |
Technical Questions
What is specified for location?
Camera-side adapter set.
What is specified for signal?
RS-232 serial control.
What is specified for connections?
8-pin serial to CAT cable via RJ45.
Buying and Installation Questions
What is the CV620-CABLE-07 used for?
It is intended for the compatible equipment and installation described in the specifications.
What should I check before ordering?
These RJ45 connections carry serial control. Do not connect them to an Ethernet or PoE switch.
