This premium 75 Foot Component Video Cable
is 1080p (1080p, not 1080i) tested before we ship so you'll have the finest high definition video possible. The component video cable will not only support the fast 1080p signal but of course will support todays resolutions of 480i / 480p / 720p and 1080i.
All of our cables have gold plated connectors which resist corrosion 100 times better then non-plated connectors. Many home theater applications require the cables be installed inside walls, fireplaces or other moisture rich areas and using our gold plated connectors assures you that you will not have any future corrosion issues that may result in a bad high definition picture.
75 Foot Component Video Cable Features:
- This component video cable is tested to 1080p (1920 x 1080 @ 24 Hz) to assure you of the best picture available today with ANY cable
- All wire gauge is a heavy 23 AWG assuring you of flawless video, even with this 75 foot cable
- UL CL2 rating
- 24 Kt gold plated connectors
- Superb build quality to look good in your home theater
- Very accurate 75 ohm impedance to match your devices
- (3) red, green and blue male connectors on both ends
- Oxygen free copper conductors pass the very fast high definition signal without any video imperfection
This high performance 75 Foot Component Video Cable
is specially designed to transfer a 1080p signal. The 1080p component video cable is made of a pure Oxygen Free Copper (OFC) conductor which has the characteristics of high conductivity, low signal loss and degradation, low electric resistance and good signal transmission. In addition, by utilizing a triple shield technology on each one of three signal carriers, this 1080p component video cable will reject a maximum amount of EM and RF interference.
Todays component video cables, nearly twice what we have today...and todays component video cables will not be able to transfer the 148.5 Mhz signal needed to accommodate this demanding resolution.Applications:
This 75 Foot Component Video Cable is primarily used to interconnect video equipment like upscaling DVD players, audio/video cable, Tivo and satellite high definition receivers, Plasma displays, LCD's projectors and more.Tip:
It's always a good practice when using long cables that are installed in walls to test your component video chain out first by laying the cables on the ground and plugging them into you source devices and HDTV before installing them. It's far easier to diagnose problems this way then when they are in the wall. The more the timing variance between the red, green and blue wires, the less detail can be seen in the high definition picture. All of our component video cables have a maximum of 2.0 nanoseconds delay per wire per 100 ft. This is >10X better than the broadcast industries maximum of 40 nanoseconds. This means our component video cables provide you the sharpest, clearest HDTV picture available today.
Component video carries signal over three discrete paths for better picture clarity than composite and S-Video signals. A component video cable is split into the red, green and blue primary colors and the signals must arrive at the same time at the end of the cable no matter how long it is.NOTE:
These component video cables are tested to pass a 1080p signal however you might still require a booster depending upon your source device. Some source devices do not have enough voltage and current to drive a long cable. Please see our component video cable boosters
if you feel your component video device source device can't drive long cables.
Why not buy this 75 Foot Component Video Cable today?