Burst Electronics SG-7-TONE-U 6 Black Burst Out 1 SMPTE Bars Out -With Unbal Audio
The SG-7 Color Bar/Black Burst Generator is a low cost generator that produces one output of SMPTE Color Bars and six outputs of Black Burst. The SG-7 is designed to provide genlock signals for a variety of video equipment such as source decks, edit controllers, mixers, SEGs, cameras, etc. With the addition of the SG-7 to your Edit System, all equipment is genlocked to one source. The SG-7 may be used to "lay down" bars on tape, or to correctly set the color and brightness of video monitors. The SG-7 may also be used as a video source for testing cables and adjusting equalizing DAs, etc. The output, which contains composite sync, color burst and the SMPTE Color Bar pattern (and six Black Bursts), is a standard 1 Volt signal designed to be terminated into 75 ohms. Power Supply Included.
NOTE: This product has been discontinued. See the above SIMILAR Tab for equivalent products or, if not there, call us at 800-841-9238 right now to discuss your needs.
Why not buy this Burst Electronics SG-7-TONE-U 6 Black Burst Out 1 SMPTE Bars Out -With Unbal Audio today?
Burst Electronics SG-7-TONE-U 6 Black Burst Out 1 SMPTE Bars Out -With Unbal Audio Specifications:
Output: 1 volt standard video NTSC
Output Impedance: 75 Ohms 1%
Sync Tip: -40 IRE
Black Burst: Sync, Color Burst and 7.5 IRE Setup
Burst: +/-20 IRE, 3.579545 MHz
Setup: 7.5 IRE NTSC
Video Output Connector: BNC
Output Protection: Open or Short, infinite duration