The KVM HDMI over IP PoE Extender Kit allows HDMI & USB equipment to be connected up to 330ft (100m) over an Ethernet LAN, supporting 1920x1200 and 1080p resolution @ 60Hz via Cat5e/6 cable in multiple point-to-point and point-to-multipoint configurations. The Transmitter (500770-TX) and Receiver (500770-RX) support PoE (PD) if used with a PoE (PSE) Ethernet Switch.
The Transmitter terminates to a computer server/workstation via an HDMI & USB port, The Receiver terminates to an HDMI display and up to 4 USB devices such as a keyboard, mouse, printer, drawing pad, storage device, camera, etc., via a 4 port USB hub. A single Receiver can be switched via hotkey sequences to any Transmitter on the network, allowing a single operator to manage numerous servers/workstations, in a distributed KVM application.
MuxLab 500770-RX KVM HDMI over IP PoE Transmitter Features:
One operator can manage multiple servers/workstations
Supports HDMI up to 1920x1200 and 1080p @ 60Hz
Receiver side includes a 4-port USB hub, for KVM applications
Up to 330ft (100m) over Cat5e/6
Supports 100's of Transmitters & Receivers depending on network bandwidth
Supports multiple point-to-point, and point-to-multipoint applications
Why not buy this MuxLab 500770-RX KVM HDMI over IP PoE Transmitter today?
MuxLab 500770-RX KVM HDMI over IP PoE Transmitter
Environment: HDMI 1.4
Devices: Computers and servers with HDMI monitor ports.
Transmission: Transparent to the user
Bandwidth : 300MHz
Signals: HDMI 1.4 protocol, HDCP 1.4
One (1) HDMI receptacle.
One (1) RJ45S for Cat 5e/6 unshielded or shielded twisted pair.
Two (2) 3.5mm jacks for audio insert (on TX)/audio extract (on RX).
One (1) 2.1mm locking barrel jack for power
One (1) or Four (4) USB Connector(s) for Host (on TX)/Client (on RX)
Four (4) DIP Switches for device ID addressing
Maximum Distance: Cat5e/6: 330ft (100m) up to 1920x1200 and 1080p @ 60Hz
Latency: Typical one (1) Frame (16ms), maximum 2 frames (33ms)
Compression: JPEG 2000
Bandwidth: Up to 315Mbps
Network Requirement: 1000BaseT with PoE
RJ45 Pin Configuration
Pin 1 (R)
Pin 2 (T)
Pin 3 (R)
Pin 6 (T)
Pin 4 (R)
Pin 5 (T)
Pin 7 (R)
Pin 8 (T)
Cable: One (1) Cat 5e/6 or better twisted pair cables required
Power Source: This device supports PoE (PD), an external power supply is not included. It is intended to be powered via a PoE (PSE) Ethernet Switch. If required, an optional power supply (500993) may be purchased separately
PoE Standard: IEEE 802.3af
Power Consumption: Transmitter - 2.85Watt
Operating: 0˚ to 40˚C
Storage: -20˚ to 85˚C
Humidity: Up to 95% non-condensing
Dimensions: 4.40" x 5.08" x 1.00"(112mm x 129mm x 25mm)