Hall Research U97-Ultra-2B All-In-One Console Extender
Hall Research U97-Ultra-2B All-In-One Console Extender is used to extend Dual Display PC Video, Stereo Audio (amplified or line level), RS-232, and up to 3 independent USB ports to a remote location up to 500 feet away on any Category Cable (CAT5e/6 etc).
These products include a rack-mountable Sender Unit plus a wall-mountable Receiver (and I/O hood cover), packaged together. However they can also be sold separately under the U97-Ultra-2B-R and U97-Ultra-2B-S Part #'s.
Hall Research U97-Ultra-2B All-In-One Console Extender Features:
Combines the functions of Hall Research Models U97-H2, UU2X4-P1, two SKU-RGB, DVC-3 video test pattern generator, and more
Eliminates the need for Utility Box (Receiver includes a guard plate that goes over all the connectors with tie-down provisions for strain relief)
Does not require external power supply (built-in supply with standard 110~240 VAC IEC320 jack)
Includes 2 "Direct" USB ports (DR1 & DR2), and a Standard with Hub at receiver.
DB15 connector for Amplified audio input and loop output at the sender as well as DB15 output at the receiver to directly drive passive speakers
Built-in video Skew Correction on both video channels. This corrects the lack of RGB convergence when long Cat6 cables are used. Eliminates the need to use special low-skew UTP cables for long runs
Built-in Test pattern generator for long cable compensation (High Frequency Gain) and Skew correction.
Supports DDC channel with EDID (Extended display ID)
Hall Research NOTE: HDTV Supply supports our Federal, State & Local Governments, Schools, Universities & Military accounts by offering an additional discount if your email address ends in .EDU & .GOV & .MIL & .ORG. Please see Options below.
Why not buy this Hall Research U97-Ultra-2B All-In-One Console Extender today?
Hall Research U97-Ultra-2B All-In-One Console Extender Specifications
Video Inputs: PC outputs (VGA to WQHD)
Resolutions: PC resolutions up to 2560x1440 @ 60 Hz
Video Levels: 0 to 0.7v p-p
Sender (H x W x D) - 1.5 x 19 x 5.06 inch
Receiver (H x W x D) - 1.75 x 14 x 4.06 inch
Receiver Cable Cover (H x W x D) - 1.75 x 13 x 4 inch
Sender - 4 Lbs
Receiver - 3 Lbs
High Speed devices (12Mb/s)
Low Speed devices (1.5Mb/s)
High Speed devices on DR1 and DR2 only (480Mb/s)
UTP Cable: Up to 330 feet using any Cat5e or 500 ft using Cat6