Intelix DIGI-HDXL-S 150m HDBaseT HDMI, Ethernet, RS232 & Bi-Directional IR - Transmitter

Intelix DIGI-HDXL-S 150m HDBaseT HDMI, Ethernet, RS232 & Bi-Directional IR - Transmitter
extends HDMI over a single cable by incorporating HDBaseT technology. The DIGI-HDXL-S supports 1080p video signals up to 150 meters (492 feet) including multichannel audio. Built-in surge protection and diagnostic LEDs ensure hassle-free and robust installations. Key features of the new extender series include local HDMI output on the transmitter, power over Ethernet (PoE), bidirectional IR, bidirectional RS232, and Ethernet pass-through with a 2-port network switch on the receiver.

The HDMI distribution chip in the DIGI-HDXL-S sends one signal to the HDBaseT output and the other signal to the local HDMI output for a local display. This new feature also allows HDMI source devices that do not support DDC clock stretching (HDMI 1.2 and below) to be extended over the HDBaseT link without issues. Flexible power design allows the DIGI-HDXL series extenders to be powered at either the TX or RX end, and only one power supply is required. The power supply (PS-24D-25) is sold separately. The bidirectional wideband IR, bidirectional RS232, and Ethernet pass-through capabilities make the DIGI-HDXL compatible with most control systems.

The DIGI-HDXL series extenders are only compatible with Intelix XL-series HDBaseT product offerings. An HDBaseT link will not be established with other HDBaseT products.

Intelix DIGI-HDXL-S 150m HDBaseT HDMI, Ethernet, RS232 & Bi-Directional IR - Transmitter Features:

HDMI transmission up to 150m (492 ft)
HDMI loop out; locking power connector
Supports 1080P/24bit and audio formats up to 7.1 audio
Supports HDBaseT, CEC specifications; HDMI/HDCP compliant
Built-in surge protection, diagnostic LEDs
Bidirectional Wideband IR, RS232 and 100BaseT Ethernet pass-through
PoE (Power over Ethernet) - power from RX (PS not included) when used with DIGI-HDXL-R

Applications

Works with Scientific Atlantic or Cisco cable boxes
Extension of HDMI and control signals up to 150 meters
Limited access to power for extenders on both ends
Ideal for digital signage, home theater, commercial video systems

Why not buy this Intelix DIGI-HDXL-S 150m HDBaseT HDMI, Ethernet, RS232 & Bi-Directional IR - Transmitter today?

Intelix DIGI-HDXL-S 150m HDBaseT HDMI, Ethernet, RS232 & Bi-Directional IR - Transmitter Specification:

Input/Output Connections

HDMI Input: One (1) HDMI Type A Receptacle Connector
HDMI Output: One (1) HDMI Type A Receptacle Connector
Twisted Pair (HDBaseT): One (1) Shielded RJ45 Female
RS232: One (1) 3-Pole Euroblock connector
Ethernet: One (1) Shielded RJ45 Female
IR Input: One (1) 3.5mm TRS
IR Output: One (1) 3.5mm TS
24V DC Power: One (1) 5.5 mm Outside Diameter, 2.1 mm Inside Diameter Barrel

Supported Audio, Video, and Control

Maximum Video Compatibility: Deep Color 24 Bit at 1080p
Video Compliance: HDMI, HDCP, and CEC (Consumer Electronics Control)
Embedded Audio: Up to PCM 8 channel, Dolby Digital TrueHD, and DTS-HD Master Audio
Input DDC Signal: 5.0 volts p-p (TTL)
Input Video Signal: 0.5 to 1.0 volts p-p
IR Carrier Frequency Range: 33-55kHz at 5 volts
Ethernet: 100BaseT
RS232 Baud Rate: Up to 115200 baud

HDBaseT Signal Characteristics

Maximum Distance: 150 m (492 ft)
Cable Requirements: Solid core shielded Category 5e, Category 6 or greater with TIA/EIA-568B crimp pattern
Gain: 0 dB - 10 dB at 100 MHz
Signal to Noise Ratio (SNR): > 70 dB at 100 MHz over 100 m
Return Loss: < -30 dB at 5 KHz
Total Harmonic Distortion (THD): < 0.005% at 1 KHz
Min-Max Signal Level: < 0.3 V - 1.45 Vp-p
Differential Phase Error: ±10˚ at 135 MHz over 100 m