Buying from HDTV Supply gives you access to >6,000 discounted AV products to choose from, free lifetime tech support, secure shopping and shipping anywhere in the world and usually on the same day.
These Component Video Distribution Amp Splitter are very wide band analog Distribution Amplifiers (DA) capable of buffering & splitting any nominal 1 to 2 Volt (peak to peak) signal that terminates into the appropriate 75 ohms.
Component Video Distribution Amp Splitter Features
RGB / Y-Pb-Pr / component Distribution Amplifier.
Split any component video signal into 2 outputs without degradation.
Stackable - See the below application note for connecting 40 HDTV's to one source device.
Each output has its own High-Current Cable Driver.
High current output IC's drive very long cables (> 100 feet) easily. No interaction with other outputs.
Will accept any analog input, Composite Video, Y/Pb/Pr or R/G/B at any scan rate and give you 2 identical High Bandwidth (200MHz) outputs.
Supports resolutions of 480i, 480p, 720p, 1080i and 1080p.
All Connectors are Gold Plated RCA.
Great for Automotive video applications. Wide DC power supply range (8-18 VDC).
Use as SPDIF/AES-EBU (Digital Audio) DA to split PCM, DTS or AC3 Digital Audio.
Power Supply (12VDC) Included.
DESIGNED, MADE and SUPPORTED IN THE USA!!!
Perfect as a Broadcast Utility DA at a fraction of the cost.
The Sync is on green which is standard for Component Video, the R-Y and B-Y doesn't have any sync
This unit won't add the sync as whatever you put in, you'll get multiple outs.
1X2 splitter (above picture) dimensions: 2" X 3" X 2". The others are shown below.
Comes with a 3 foot or 6 foot component video cable (Tell us which)
The unit is supplied with the proper DC Power Supply
(center pin positive +) and a 3 foot component video cable.
These Component Video Distribution Amp Splitters can be configured in a number of ways. Here are the most common:
A 1-In to 2, 3 or 4-Out HDTV Component Video Splitter or
Three separate 1-In to 2, 3 or 4 -Out distribution amp or
Home Theater splitter. One input distributes the Composite (NTSC) video to the displays and another
input distributes the Digital Audio to the Audio
equipment
Buy (2) two if you need audio along with your component video
Each output has its own dedicated high current
Video amplifier/driver which is capable of sending
any video signal very long distances without degradation.
Your video is only as good as the splitter that connects it. Why not buy this a Component Video Distribution Amp Splitter today?
The Component Video Distribution Amp Splitter are a very wide band analog Distribution Amplifier (DA) capable of buffering and splitting any nominal 1 to 2 Volt (peak to peak) signal that terminates into 75 ohms. This includes any of the following:
HDTV Analog RGB/Y-Pb-Pr signals or
Standard Def. Analog RGB/Y-Pb-Pr/Betacam or
Component DVD, Progressive or Interlaced or
Composite Video (NTSC) or
SPDIF Digital Audio (PCM/AC3/DTS)
Q: Can I split Analog Audio with these component splitters A: Yes, but the level (Volume) can drop from 2dB to 30dB due to the low input impedance (75 ohms).
Some audio equipment with low enough output impedance can feed this DA with acceptable results, but most will have a high impedance that will cause unacceptable signal loss.
Q: Can I split Digital Audio (SPDIF)? A: Yes. SPDIF is just AES/EBU digital audio that is designed to run over Coax cable just like video.
